Illustrative sample scenario

Support-Heavy Miniature

A detailed miniature whose overhangs, contact scars, and cleanup labor dominate the job.

See what needs attention Back to all samples
Off-white fantasy knight miniature enclosed in dense print supports with contact points highlighted red-orange.
Not scored · Unscored teaching scenario

What this example is teaching

These illustrative findings are tied to this exact scenario—not a generated customer result and not a guarantee for another file.

Image typeIllustrative 3D diagnostic visualization
What this image cannot prove

The picture shows dense supports and likely cleanup work. Exact contact areas, printability, and labor depend on orientation, process, and the target slicer.

Support cost

Dense supports add material and labor.

Removal damage

Fine projections are vulnerable during removal.

Process choice

Resin and FDM require different preparation assumptions.

Open the full illustrative Sample Report to see the complete report structure.

Apply the lesson

What to bring to the next check.

Use the actual file and job requirements. This illustration does not supply a model, slicer settings, or a production result.

  1. Choose the surfaces that matter. Mark the face, fine details, or contact surfaces that should avoid support scars.
  2. Compare two orientations. Inspect your model in Studio, then use your slicer to compare support contacts, print time, and removal access.
  3. Record the observed tradeoff. Use the actual sliced job to estimate support material and cleanup work; confirm the physical result with a representative test where needed.

Open your own file in Studio. This page does not transfer a miniature or a saved setup.

Inspect the model before choosing supports.

Bring a supported model to Studio, then validate the chosen orientation and support settings in your slicer.

Review your model in Studio